In the process of using oil press, no matter automatic oil press or traditional oil mill, circumstance like less oil yield would appear more or less. Then, what’s reason for the lower oil yield of oil press?
Under general conditions, it is mainly due to the blocking of pressing bar by oil dregs and detritus or the pressing bar is installed too tight. If such circumstance appears in the process of inspection, we just need to clean up the oil dregs or detritus and adjust the firmness of pressing bar.
In the actual use of oil press, such circumstance would also appear if the moisture content of material is higher or hollow kernels are used. Then, what we need to do is to control the quality of raw materials.
Also in the actual operation process, if the parts of oil press wear seriously, the circumstance would appear as well. Under this condition, replacement should be made. Otherwise, raw materials would be wasted and there will be a lot of unnecessary trouble in the actual operation process.
What cannot be ignored is that before pressing with automatic oil press each time, preheating of the machine should be made. Under the general condition, the preheating temperature in spring and summer is usually between 50-70 degrees. In autumn and winter, the preheating temperature is usually between 70-90 degrees. If the temperature can not be well controlled, it would have large influence on the future operations.